P0201, P0202, P0203, P0205, P0300, P0301, P0302 Audi Fault Codes

We are an award winning independent garage that can service your Audi vehicle fault codes. We invest in all of the latest Audi tech that will help us get to the heart of the problem your Audi is experiencing at our garage workshop pictured below.

A break down of Audi fault codes P0201, P0202, P0203, P0205, P0300, P0301, P0302 your experiencing

P0201 Defective Fuel Injector, Faulty or corroded Fuel Injector, wiring, and/or connections, Plugged Fuel Injector, Dirt in the Fuel Injector

P0202 Malfunction of the Fuel Injector, Malfunction of the PCM Fuel Injector driver circuit, Defective wiring/connections in the Fuel Injector wiring harness, Defective Fuel Injector power circuit(s)

P0203 Fuel injector failure, Powertrain Control Module (PCM) failure, Wiring issue

P0205 Fuel injector failure, Powertrain Control Module (PCM) failure, Wiring issue

P0300 Worn out spark plugs, ignition wires, coil(s), distributor cap and rotor (when applicable), Incorrect ignition timing, Vacuum leak(s), Low or weak fuel pressure, Improperly functioning EGR system, Defective Mass Air Flow Sensor, Defective Crankshaft and/or Camshaft Sensor, Defective Throttle Position Sensor, Mechanical engine problems (i.e.—low compression, leaking head gasket(s), or valve problems)

P0301 Worn out spark plugs, ignition wires, coil(s), distributor cap and rotor (when applicable), Incorrect ignition timing, Vacuum leak(s), Low or weak fuel pressure, Improperly functioning EGR system, Defective Mass Air Flow Sensor, Defective Crankshaft and/or Camshaft Sensor, Defective Throttle Position Sensor, Mechanical engine problems (i.e.—low compression, leaking head gasket(s), or valve problems)

P0302 Worn out spark plugs, ignition wires, coil(s), distributor cap and rotor (when applicable), Incorrect ignition timing, Vacuum leak(s), Low or weak fuel pressure, Improperly functioning EGR system, Defective Mass Air Flow Sensor, Defective Crankshaft and/or Camshaft Sensor, Defective Throttle Position Sensor, Mechanical engine problems (i.e.—low compression, leaking head gasket(s), or valve problems)

Contact us

If you need to diagnose any of the following Audi fault codes P0010, P0011, P0012, P0013, P0014, P0101, P0102 then call us. We have the dealer level tech needed to not only diagnose the fault but to fix it as well. Use the contact information below or contact form to book your vehicle in for a diagnostic. We are happy to help.

A1-Diagnostics
64 Sloper Road
Leckwith,
Cardiff
CF11 8AB

Tel: (029 20) 220380
Fax: (029 20) 223172

Opening Times

Mon – Fri: 8:00am – 6:00pm

Email: info@a1-diagnostics.com